TSI Recertification
Texas: Corpus Christi - Kilgore - Odessa Pennsylvania: Bridgeville - Towanda

TSI Recertification - safely Go With The Flow

Inspection and certification of oilfield equipment

Why should you use TSI Recertification?

  • All locations work under an ACCPP Professional Level III inspector (ASNT #8280).
  • This procedure establishes the specific requirements for qualification and certification of personnel performing nondestructive testing for TSI Flow Products, LLC. This procedure is based on the recommendations set forth in the American Society for Nondestructive Testing (ASNT), Recommended Practice SNT-TC-1A, 2006 Edition. This procedure addresses the qualification steps required for the certification in the NDT applications used by the company.
  • As part of a vertically-integrated manufacturing and distribution team, TSI Flow Products is able to offer engineering and technical expertise unmatched by smaller, less-integrated inspection companies that may not have the same level of resources to access.
  • TSI Recertification has implemented a continuing education plan for all inspectors. TSI's inspectors regularly attend inspection schools to upgrade and further their inspection levels. TSI allocates a large amount of capital and time per year to ensure that all inspectors are highly-trained.
  • TSI Recertification has an Iron Management Program that is accessible to its customers 24 hours a day.
  • TSI Recertification is fully-insured.
  • All equipment is calibrated annually.

LEVEL 1 INSPECTION

  • Visual Inspection
  • UT Wall Thickness
  • Grind Wing Nut
  • Clean Connections
  • Hydrostatic Test
  • Band

LEVEL 2 INSPECTION

  • Visual Inspection
  • UT Wall Thickness
  • Grind Wing Nut
  • Clean Connections
  • Clean OD & ID of Equipment to Bare Metal
  • Hydrostatic Test
  • Band
  • Primer & Paint Back to Customer Color
    [NOTE: paint used is crown industrial primer and paint; any specialty paint must be provided by customer or, if bought, will be charged back to customer.]

LEVEL 3 INSPECTION

  • Visual Inspection
  • UT Wall Thickness
  • Grind Wing Nut
  • Clean Connections
  • Clean OD & ID of Equipment to Bare Metal
  • Hydrostatic Test
  • Band
  • Primer & Paint Back to Customer Color
    [NOTE: paint used is crown industrial primer and paint; any specialty paint must be provided by customer or, if bought, will be charged back to customer.]
  • Wet or Dry Magnetic Particle Inspection
  • UT Shear Wave or UT Phased Array on Welds
    [NOTE: customer must provide minimum wall thickness and MAWP for equipment being inspected.]